The Pro-Ject Pick It MM E Stylus is the factory replacement stylus assembly for the Pick it MM E moving-magnet phono cartridge. When your stylus reaches the end of its service life, fitting a fresh assembly restores the cartridge to its original performance without replacing the generator or cartridge body.
Conical Diamond Stylus
The stylus assembly uses a conical diamond tip mounted in a low-mass cantilever. Whilst conical profiles are shared across entry-level cartridges, Pro-Ject has optimised the assembly for the Pick it MM E specifically. The conical tip delivers a warm, smooth character with low background noise, making it well suited to everyday listening and well-pressed records alike.
Low Mass Neodymium Generator
The Pick it MM E uses a miniature neodymium generator magnet, which lowers the moving mass of the entire assembly. The replacement stylus slots directly into this generator, maintaining the lower inertia that gives the cartridge its tracking accuracy and clean high-frequency reproduction.
Simple Snap-Fit Replacement
The stylus housing locates precisely onto the Pick it MM E cartridge body using a snap-fit connection. No tools are required. The entire swap takes seconds, and correct alignment is guaranteed by the shaped housing. Pro-Ject recommends replacement after approximately 500 hours of use to preserve stylus and record condition.
Compatibility
This stylus assembly is compatible exclusively with the Pro-Ject Pick it MM E cartridge body. It is not compatible with other Pick it MM variants such as the Pick it MM 5 or Pick it MM EVO.